Tech4Service Ltd · Edmonton, AlbertaCall (780) 264-9262

Documented electronics board repair · November 2026

Fire-Lite MS-5UD-3 — battery connector pin repair

Tech4Service performed board-level work on the damaged battery connector contacts of a Fire-Lite Alarms by Honeywell fire alarm control panel. Original photographs document the J12 contact damage and replacement-pin alignment.

Damaged J12 battery connector contacts and surrounding board before repair
Original J12 battery connection before the pin repair.
New and adjusted battery contact pin at J12 after rework
Replacement contact pin and alignment work at the J12 battery connector.
Fire-Lite control board with battery lead connector at J12 after pin alignment
Battery cable connector fitted at J12 after contact work.

What was damaged?

The original photos show damaged battery connection contacts at J12, directly below the relay on the controller PCB. Battery backup connects to this connector. A damaged connection can affect the backup-battery circuit.

Repair performed

We repaired the damaged battery connector pin area and installed or adjusted replacement contact pins for proper alignment. The photographs show the damaged connector area, subsequent contact rework and the battery cable plug placed on J12. This is a documented component-level repair, not proof of complete control-panel operation.

Identification

The board is marked MS-5UD-3. The provided Fire-Lite Alarms by Honeywell manual covers the MS-5UD and MS-10UD control-panel series and identifies J12 as the battery cable connection.

Need an electronics board assessment?

Tech4Service provides electronic component diagnostics and board-level repair assessments in Edmonton. Work on life-safety systems requires separate review and authorization by a qualified fire-alarm professional.

More electronics board repair · More documented repairs